Daher TBM 700

The FAA is superseding Airworthiness Directive (AD) 2007-06-11 (AD 2007-06-11) for certain SOCATA (type certificate now held by DAHER AEROSPACE) Model TBM 700 airplanes. AD 2007-06-11 required repetitively inspecting the vertical stabilizer attachment fittings and bolts for cracks or corrosion, and, if necessary, repairing or replacing the damaged part and then applying a corrosion protection reinforcement. Since the FAA issued AD 2007-06-11, the European Union Aviation Safety Agency (EASA), which is the Technical Agent for the Member States of the European Union, superseded the previous Direction generale de l'aviation civile (DGAC) France AD to introduce new service information providing instructions for installing new vertical stabilizer attachment fittings having improved corrosion resistant material as an optional terminating action for the repetitive inspections. This AD retains the requirements of AD 2007-06-11 and includes a new optional terminating action for the repetitive inspections. The FAA is issuing this AD to address the unsafe condition on these products.

The FAA is adopting a new airworthiness directive (AD) for certain DAHER AEROSPACE (DAHER) Model TBM 700 airplanes. This AD was prompted by certain existing emergency procedures in the pilot's operating handbook (POH) that cannot be fully accomplished since certain equipment cannot be disconnected by the pilot(s) from the flight deck. This AD requires revising the existing POH for your airplane to provide the flight crew with corrected emergency procedures. The FAA is issuing this AD to address the unsafe condition on these products.

The FAA is adopting a new airworthiness directive (AD) for certain DAHER AEROSPACE (DAHER) Model TBM 700 airplanes. This AD was prompted by reports of wear of the inner flap actuator drive nut. This AD requires cleaning and lubricating the internal actuator rods, measuring the play between the drive nuts and the internal actuator rods, and if any play is found, replacing the drive nuts. This AD also allows replacing the drive nuts with certain other design drive nuts as terminating action for the requirements. The FAA is issuing this AD to address the unsafe condition on these products.

The FAA is adopting a new airworthiness directive (AD) for certain DAHER AEROSPACE (type certificate previously held by SOCATA) Model TBM 700 airplanes. This AD was prompted by mandatory continuing airworthiness information (MCAI) issued by the aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI identifies the unsafe condition as interference between the emergency exit trim panel and the upholstery panel, which could result in additional effort required to open the emergency exit door. This AD requires modification of the gripping strap, which maintains the upholstery panel on the emergency exit trim panel. The FAA is issuing this AD to address the unsafe condition on these products.

The FAA is adopting a new airworthiness directive (AD) for certain Daher Aerospace (type certificate previously held by SOCATA) (Daher) Model TBM 700 airplanes. This AD results from mandatory continuing airworthiness information (MCAI) originated by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The unsafe condition that is the subject of the MCAI is ice accumulation on the oil cooler air inlet duct fin. This AD requires modifying the oil cooler air induction duct. The FAA is issuing this AD to address the unsafe condition on these products.