Boeing 787

The FAA is adopting a new airworthiness directive (AD) for certain The Boeing Company Model 787-8, 787-9, and 787-10 airplanes. This AD was prompted by reports of door assist handles pulled loose from their lower attach point in the doorway support bracket during pre-flight checks. This AD requires, for certain airplanes, installing a new retainer above the lower keyway of the support bracket assembly and installing a placard on certain support bracket assemblies or marking the part, and for certain airplanes, requires an inspection of the forward and aft door assist handles and applicable on-condition actions. For certain other airplanes, this AD requires installing a new retainer above the lower keyway of the support bracket assembly at certain locations and reidentifying the support bracket assembly. The FAA is issuing this AD to address the unsafe condition on these products.

The FAA is adopting a new airworthiness directive (AD) for certain The Boeing Company Model 787-8, 787-9, and 787-10 airplanes. This AD was prompted by reports of an uncommanded change to the mode control panel (MCP) selected altitude. This AD requires replacing the existing MCP with an updated MCP and performing an installation test. The FAA is issuing this AD to address the unsafe condition on these products.

The FAA is adopting a new airworthiness directive (AD) for all The Boeing Company Model 787-8, 787-9, and 787-10 airplanes. This AD was prompted by the determination that radio altimeters cannot be relied upon to perform their intended function if they experience interference from wireless broadband operations in the 3.7-3.98 GHz frequency band (5G Lower C-Band) while operating in Canadian airspace, and the determination that as a result of this interference, certain airplane systems may not properly transition from AIR to GROUND mode when landing on certain runways, resulting in a longer landing distance than normal due to the effect on thrust reverser deployment, speedbrake deployment, and increased idle thrust. This AD requires revising the existing airplane flight manual (AFM) to incorporate limitations prohibiting certain operations requiring radio altimeter data when operating in Canadian airspace. The FAA is issuing this AD to address the unsafe condition on these products.

The FAA is superseding Airworthiness Directive (AD) 2023-08- 04, which applied to certain The Boeing Company Model 787-8, 787-9, and 787-10 airplanes. AD 2023-08-04 required a detailed visual inspection of all door 1 and door 3 lavatory and galley potable water systems for any missing or incorrectly installed clamshell couplings, and applicable on-condition actions. This AD was prompted by discoveries by Boeing that some couplings did not have the required safety strap and that they have developed a design solution that replaces the couplings with couplings that have safety straps. This AD retains the requirements of AD 2023-08-04 and requires, for certain airplanes, a detailed inspection of all clamshell couplings for the presence and correct installation of safety straps at door 1 and door 3 lavatories and galleys with a potable water system and applicable on-condition actions, which would terminate the existing requirements. This AD also prohibits the installation of affected parts at inspection locations. The FAA is issuing this AD to address the unsafe condition on these products.

The FAA is adopting a new airworthiness directive (AD) for certain The Boeing Company Model 787-8, 787-9, and 787-10 airplanes. This AD was prompted by a report of multiple instances of loss of transponder for airplanes entering airspace in the presence of continuous wave (CW) interference where the transponder did not meet the minimum operational performance standards (MOPS) requirement for transponder response. This AD requires replacing the left and right integrated surveillance system processor unit (ISSPU) hardware. The FAA is issuing this AD to address the unsafe condition on these products.