Boeing 767-300F

The FAA is adopting a new airworthiness directive (AD) for all The Boeing Company Model 757 airplanes and Model 767 airplanes. This AD was prompted by the determination that radio altimeters cannot be relied upon to perform their intended function if they experience interference from wireless broadband operations in the 3.7-3.98 GHz frequency band (5G Lower C-Band) while operating in Canadian airspace, and a determination that, during approach, landings, and go-arounds, as a result of this interference, certain airplane systems may not properly function, resulting in increased flightcrew workload while on approach with the flight director, autothrottle, or autopilot engaged, which could result in reduced ability of the flightcrew to maintain safe flight and landing of the airplane. This AD requires revising the existing airplane flight manual (AFM) to incorporate limitations prohibiting certain operations requiring radio altimeter data when operating in Canadian airspace. The FAA is issuing this AD to address the unsafe condition on these products.

The FAA is adopting a new airworthiness directive (AD) for certain The Boeing Company Model 767-200, -300, -300F, and -400ER series airplanes. This AD was prompted by discovery of a crack at one of the forward lower fastener holes following replacement of a cracked underwing longeron (UWL) fitting. This AD requires performing an open hole high frequency eddy current (HFEC) inspection for cracks of the fastener holes common to the UWL fitting, upper drag splice angle, and lower drag splice angle, and applicable on-condition actions. The FAA is issuing this AD to address the unsafe condition on these products.

The FAA is adopting a new airworthiness directive (AD) for certain The Boeing Company Model 767-200 and 767-300 series airplanes. This AD was prompted by reports of scribe lines found at skin lap joints and butt joints, around external repairs and antennas, and at locations where external decals had been cut. For some airplanes, this AD requires a detailed inspection for scribe lines and applicable related investigative and corrective actions. For other airplanes, this AD requires repetitive nondestructive testing inspections for cracking at certain stringers of the skin lap joint fuselage skin and applicable corrective actions. The FAA is issuing this AD to address the unsafe condition on these products.

The FAA is adopting a new airworthiness directive (AD) for certain The Boeing Company Model 767-200, 767-300, 767-300F, and 767- 400ER airplanes. This AD was prompted by a heavy maintenance check that found corrosion damage on a Model 767 satellite communications (SATCOM) high gain antenna adapter plate. This AD requires repetitive detailed inspections (DET) of the SATCOM high gain antenna adapter plate for corrosion and applicable on-condition actions. The FAA is issuing this AD to address the unsafe condition on these products.

The FAA is superseding Airworthiness Directive (AD) 2025-01- 06, which applied to all The Boeing Company Model 767-200, -300, -300F, and -400ER series airplanes. AD 2025-01-06 required identifying the part number, and the serial number if applicable, of the Captain's and First Officer's seats and applicable on-condition actions for affected seats. AD 2025-01-06 also required a one-time detailed inspection and repetitive checks of the horizontal movement system (HMS) of the Captain's and First Officer's seats and applicable on-condition actions. Since the FAA issued AD 2025-01-06, the FAA determined that AD 2025-01-06 contains an error when providing conditions for taking credit using a previous revision of the service information. This AD requires the actions of AD 2025-01-06 and revises paragraph (j) of this AD to clarify which actions are not required. The FAA is issuing this AD to address the unsafe condition on these products.