REPAIR

No summary available - see the EASA publication.

The FAA is superseding Airworthiness Directive (AD) 2018-02- 10, which applied to certain Pratt & Whitney Division (PW) Model PW4074, PW4074D, PW4077, PW4077D, PW4084D, PW4090, and PW4090-3 engines. AD 2018-02-10 required performing repetitive fluorescent penetrant inspections (FPIs) to detect cracks in the outer diffuser case (ODC), removal of any ODC that fails inspection, and updating the mandatory inspections in the Airworthiness Limitations Section (ALS) of the Instructions for Continued Airworthiness (ICA). Since the FAA issued AD 2018-02-10, PW developed a modification to reduce the susceptibility of ODC cracking. This AD retains the ALS update requirement from AD 2018-02-10, requires replacing certain ODC part numbers with parts eligible for installation, expands the applicability to all ODC part numbers, and adjusts the compliance threshold of the FPIs of the ODC. The FAA is issuing this AD to address the unsafe condition on these products.

The FAA is adopting a new airworthiness directive (AD) for certain Bombardier, Inc., Model BD-700-2A12 airplanes. This AD was prompted by a report that some of the multi-function spoiler (MFS) anti-rotation plates failed in-service due to a thin wall design. This AD requires replacing the MFS anti-rotation plates, inspecting the MFS anti-rotation plates for cracking and hinge bolts for evidence of rotation, accomplishing applicable corrective actions, and performing a functional test of the MFS control surfaces. The FAA is issuing this AD to address the unsafe condition on these products.

The FAA is superseding Airworthiness Directive (AD) 2021-10-09 for certain CFM International, S.A. (CFM) CFM56-5B and CFM56-7B model turbofan engines with a certain high-pressure turbine (HPT) inner stationary seal installed. AD 2021-10-09 required removal, inspection, and replacement of the affected HPT inner stationary seal and, depending on the findings, replacement of the rotating air HPT front seal, HPT rotor blades, and No. 3 ball bearing. This AD was prompted by cracks found in the rotating air HPT front seal. After the FAA issued AD 2021-10-09, the manufacturer notified the FAA that the service information incorrectly lists the year of certain honeycomb repairs and that affected HPT inner stationary seals could potentially be installed on CFM CFM56-5C model turbofan engines. This AD requires removal, inspection, and replacement of the affected HPT inner stationary seal and, depending on the findings, replacement of the rotating air HPT front seal, HPT rotor blades, and No. 3 ball bearing. This AD also revises the applicability to add CFM CFM56-5C model turbofan engines. The FAA is issuing this AD to address the unsafe condition on these products.

The FAA is adopting a new airworthiness directive (AD) for certain type certificated Model UH-1H restricted category helicopters. This AD was prompted by multiple reports of failure of the main driveshaft. This AD requires establishing a limit to replace certain main driveshafts, and a one-time and repetitive inspections of the main driveshafts. The FAA is issuing this AD to address the unsafe condition on these products.